| This product is made by new technology, Lightning Protection Design,Only the single could make 10/100M Ethernet (Including ADSL, HFC, FTTB, +LAN connect and so on) as 10M full-duplex speed to transmission single up to 300 meters above, when used as repeater up to 600 meters, support multiple-tandem. If the two Ethernet extender which is tandem could make the actual distance up to 1,000 meters, one input four output, could used once plug, simple and reliable, can be easily achieved switch, HUB, Router, ADSL, Network Card. Ethernet Industrial Control Equipment, Security Equipment etc, the long distance of any combination of these interconnection, also could be used as HUB, help to quickly layout decentralized Ethernet and Internet. The basic principle is that through the signal shaping, increased sensitivity to realize the distance extension of its Voltage and waveform completely in line with the national standard of Ethernet, will not harm the network, Please be assured that used in the CAT5 or UTP unshielded cable. In the front of Indicator shows: Power light indicated that access to the normal power supply. Indicator Description: UP light showed that uplink is proper and efficient, Flashes is showed to transfer data. 1, 2, 3, 4 light showed that downlink is proper and efficient. Flashes is showed to transfer data. The interface in the behind description: Power plug, the power adapt input is 220V, output DC9V Direct connection into the uplink port (cross in conjunction with the Direct Connect can not be used simultaneously) Direct connection in the downlink port (cross in conjunction with the Direct Connect can not be used simultaneously) Direct connect insert direct connection port is connect with common port, such as up-switch, HUB, router, Network Card. If connected with uplink port, should be use the cross-line (as the line sequence diagram) into the fork port of the extender.1, 2, 3, 4 port respectively as four down ( output ) port , Generally connect with calculator 10M or 10M/100M network card, It is Direct connection sequence.If connect with poor quality cable or sub –switch, HUB, Router, Network card and so on will reduce the transmission distance. Generally speaking, it will not less than 70%, for assured that Please try pass before wiring, and leave some redundancy. Please note before installation:1.cable line whether correct( It can make this device as the HUB routing )2.whether make the corresponding direct or cross network cable into correct interface3.power supply whether is normal ( Power light is normal)4.whether set the network card automatically as 10M/100M ( Turn Click: My computer- Contral panel- System- Hardware-Device Manager-Network Card Properties- Advanced-Value set)5.Check the IP address of terminal computer setting, to avoid conflict with the network6.Sometimes, it needs tens of seconds which could connect automatically7.In case of device connected and the signal indicator light, however, it is block-up. Only needs to shortened a few meters of the cable.8.Since the product is that down-side and up-side each are 350 meters to achieve the transmission of 700 meters, please be placed in the effective regulation within the maximum transmission distance should put it in the middle. (the up-side longer than the down-side length of 30 meters)Note: This product is for indoor useful type, such as place it outside, there must be strict moisture, rain, etc. and good fixed measures, or they will short circuit, damaged. |
|
